Lamine Parkeler

[Construction - Section 247]

Veneer Parquet is exclusively indoors. Veneer Parquet is ready to lay flooring produced from mostly three layers of wood and with a real wood surface (2-5 mm). When Veneer Parquet are individually verlegenden sticks or planks already completed sealed to a carrier system upset. These sources are mostly from a lower softwood. In this way, whole plates with tongue and groove, and relocated. Ordinary Veneer Parquet are due in comparison to stave parquet much thinner layer of about only 4-6 mm and less expensively than rod or mosaic floor. Nowadays, even high-quality Veneer Parquets from tropical woods, or sometimes with leather etc., which are more expensive than the traditional mosaic parquet flooring and are more elegant. After the purchase of all types of Veneer Parquets, no grinding or painting is needed.

Laying the floor:

What kind of floor it is also, in all, the room temperature at installation time is very important. It should be the limit of 30 degrees better. Also, the moisture in the air (60 percent and not more) should not be exceeded.

Smack (with not mora than 1.5 percent moisture) is needed for rooms with warm water installation. A waiting time of two weeks is needed for dry. After the apply of the Veneer Parquets 24-48 hours the room should no more heated. After the fitting of the Veneer Parquets heating can be started gradually, so that after 3-4 days generally, the normally heating can begin. So the rest of the moisture can dry without damaging the new Parquets Veneer.